Mayday Power Float 1000mm GX160

Mayday Power Float 1000mm GX160
Enquire about this product »

Weight:

65KG

Product Description:

5Hp Belt driven machine.

Application:

The machine is used for creating a very smooth finish on new concrete slabs. In special circumstances the machine can be used for polishing screeds.

Safety:

This product should not be operated unless proper training has been supplied to the person operating the equipment. Personal protection gear includes: goggles, steel-cap boots, gloves, ear plugs, dust mask, hard-hat.

Starting:

Turn petrol on

Open choke (butterfly closes to close off air flow)

Pull recoil 1/3 of way twice

Pull recoil full way until starts (usually 2 pulls)

Close choke (butterfly opens the air flow)

Running machine:

The machine must be cleaned after working with it before concrete sets on the blades. This will lengthen the life of the machine. Check the blade arms for wear before working with it to avoid a bad finish. The blades should be flat to start with and as the job is done, the angle of the blades will be increased to create a really smooth finish. The blades should all be set the same.

Do's and Donts:

Before using the machine, start the engine and when it is on idle, the clutch should not engage. Keep away from the protective ring of the machine while the machine is working.

Shutting Down:

Turn On/Off switch off. Close fuel line.

Re-fueling:

Ensure petrol switch is off before refueling.

Machine may not be running whilst refueling.

Do not smoke or use a cell phone whilst refueling.

Remove fuel cap and place in clean dry area within reach of the machine.

Pour the fuel into the tank.

Replace fuel cap and move fuel container.

Do not place any plastic bags around the fuel cap as this will close the breather hole in the cap.

Enquire about this product »