TM Welder Generator 180 AMP/7KVA 60% Duty Cycle

TM Welder Generator 180 AMP/7KVA 60% Duty Cycle
Enquire about this product »

Weight:

125KG

Product Description:

180 AMP/7KVA 60% Duty Cycle

Application:

This machine can be used for general welding jobs. For producing burglar proofing, steel gates and fencing, steel furniture etc. It has a 220V outlet to allow it to be used as a generator to drive an angle grinder for grinding purposes.

Safety:

This product should not be operated unless proper training has been supplied to the person operating the equipment. Personal protection gear includes: goggles, steel-cap boots, gloves, ear plugs, dust mask, hard-hat.

Starting:

  • Turn petrol on
  • Ensure control lever is in neutral position before starting.
  • Open choke (butterfly closes to close off air flow)
  • Pull recoil 1/3 of way twice
  • Pull recoil full way until starts (usually 2 pulls)
  • Close choke (butterfly opens the air flow)
  • Increase the revs with the control lever before moving the machine forward or backwards

Running machine:

Check oil level and filter of of machine daily. Make sure that the welding plugs are properly fitted, not loosly fitted which can cause a short. The machine is used 6 minutes out of every 10 minutes and then should be left to cool for 4 minutes. Clean the weld end out by blowing compressed air through it at least once week. Must be set to deliver between 220V and 230V.

Do's and Donts:

Make sure that the cables are not open (connections are insulated and cables are not damaged- no bare wires showing). Never leave the engine running and electrodes connected- this leaves an open voltage circuit which can shock  persons touching the bare wires.

Shutting Down:

Turn On/Off switch off. Close  fuel line.

Re-fueling:

  • Ensure petrol switch is off before refueling.
  • Machine may not be running whilst refueling.
  • Do not smoke or use a cell phone whilst refueling.
  • Remove fuel cap and place in clean dry area within reach of the machine.
  • Pour the fuel into the tank.
  • Replace fuel cap and move fuel container.
  • Do not place any plastic bags around the fuel cap as this will close the breather hole in the cap.
Enquire about this product »